Brand New Netgear

Netgear M4300-96X 12-Slot Modular Stackable Managed Switch Empty Version

Netgear M4300-96X 12-Slot Modular Stackable Managed Switch Empty Version
Netgear M4300-96X 12-Slot Modular Stackable Managed Switch Empty Version
Netgear M4300-96X 12-Slot Modular Stackable Managed Switch Empty Version
Netgear M4300-96X 12-Slot Modular Stackable Managed Switch Empty Version
Netgear M4300-96X 12-Slot Modular Stackable Managed Switch Empty Version

Netgear M4300-96X 12-Slot Modular Stackable Managed Switch Empty Version   Netgear M4300-96X 12-Slot Modular Stackable Managed Switch Empty Version

Netgear M4300-96X 12-Slot Modular Stackable Managed Switch - Empty Version. 1.92TBps non-blocking fabric for 96x10G or 24x40G or a combination.

12 empty slots in 2RU for 8x10G or 2x40G port expansion cards (no PSU). Expands with your business as you add modules. The NETGEAR M4300-96X is a 2RU modular switch that comes either empty or pre-populated, allowing it to expand with your business as you add modules. THe M4300-96W switch is ideal for server and storage interconnect, AV-over-IP and SMB core deployments. The M4300-96W scales up to 96 ports of 10G Ethernet by multiples of 8 ports, or up to 24 ports of 40G Ethernet by multiples of 2 ports. Better than a fixed port solution, this 96-port switch lets you start small and grow later in "non-blocking" mode, just by adding port expansion cards. Serial console cable with one DB9 connector and one RJ-45 connector. USB console cable with one mini B connector and one type A connector. I/O protection blank cover in 12 front slots. PSU protection blank cover in 2 rear PSU slots. Brackets and screws for two-post rack mount (for front posts). Rails and screws for four-post rack mount (for rear posts). Resource CD with the following manuals and software links: Software setup manual, CLI manual, Software administration guide, Hardware installation guide, The driver for use with the USB console cable. Full Modularity and flexible server connections. Not sure whether your future servers and storage hosts will come with 10G Fibre or 10G Copper or 40G QSFP+? The M4300-96X has you covered with plenty of copper and fibre ports available, including 40G QSFP+ expansion cards.

Afraid of single points of failure across your virtualised servers? The M4300 two-unit horizontal stacking is cost-effective yet highly effective for HA with Link Aggregation (L2/L3/L4 LACP), load balancing and non-stop forwarding failover.

Are you filling up your racks, not sure you'll be able to skip rack units between servers for additional connectivity or redundant fabric? The M4300-96X lets you start small and scale up with expansion cards as your business expands.

The M4300 is the ideal stackable platform, reproducing Spine and Leaf data centre topologies in a stack with unrivalled ease of use. No more bottlenecks or downtime! Pre-Configured for multicast, video-over-ip and sdvoe.

IGMP Snooping, IGMP Fast Leave, IGMP Querier are already enabled for the default VLAN 1 that all your audiovisual devices will automatically use: select the collection of M4300-96X port expansion cards that fit your requirements (number of copper ports, number of fiber ports, number of PoE+ ports), insert the cards, connect your encoder and decoder AV devices, and power on the switch - it just works! Enabling Zero-Touch install of sdvoe video-over-ip. To take the complexity out of your AV-over-IP deployments, NETGEAR created M4300 switches that are preconfigured for SDVoE. Connect your SDVoE encoders and decoders, power on the switch - it just works!

Cost effective 1G access layer in campus LAN networks, and high performance 10G / 40G distribution layer for midsize organizations networks. Zero Touch AV-over-IP with pre-configured L2 Multicast (SDVoE-ready). Advanced Layer 2, Layer 3 and Layer 4 feature set - no license required - including Policy Based Routing, RIP, VRRP, OSPF and PIM. Innovative mixed "Spine and Leaf", 1G, 10G and 40G stacking with nonstop forwarding (NSF) and hitless failover redundancy.

Low acoustics, half-width 16-port and 24-port 10G models can be paired in a single rack space for redundant Top of Rack. Modular 12-slot 2RU model scaling up to 96-port 10G by multiple of 8 ports or 24-port 40G by multiple of 2 ports. Up to 768 (10 Gigabit) ports, 192 (40 Gigabit) ports or 384 (1 Gigabit) ports, or a combination in a single logical switch. PoE+ (30 watts per port) with hot swap, redundant power supplies and full provisioning.

SDN-Ready OpenFlow 1.3 support for maximum investment protection. Advanced classifier-based, time-based hardware implementation for L2 (MAC), L3 (IP) and L4 (UDP/TCP transport ports) security and prioritization. Selectable Port-Channel / LAG (802.3ad - 802.1AX) L2/L3/L4 hashing for fault tolerance and load sharing with any type of Ethernet channeling. Voice VLAN with SIP, H323 and SCCP protocols detection and LLDP-MED IP phones automatic QoS and VLAN configuration. Efficient authentication tiering with successive DOT1X, MAB and Captive Portal methods for streamlined BYOD.

Comprehensive IPv4/IPv6 static and dynamic routing including Proxy ARP, OSPF, Policy-based routing and automatic 6-to-4 tunneling. Enhanced IPv4/IPv6 multicast forwarding with IGMPv3/MLDv2 ASM and SSM Proxy and Control Packet Flooding protection. High performance IPv4/IPv6 multicast routing with PIM timer accuracy and unhandled PIM (S, G, rpt) state machine events transitioning. Advanced IPv4/IPv6 security implementation including malicious code detection, DHCP Snooping, IP Source Guard protection and DoS attacks mitigation. Innovative multi-vendor Auto-iSCSI capabilities for easier virtualization optimization. Dual redundant, modular power supplies equipping full width models contribute to business continuity management. Vertical or horizontal flexible stacking with management unit hitless failover and nonstop forwarding (NSF) across operational stack members. Spine and leaf architecture with every leaf switch (1G access switches) connecting to every spine switch (distributed 10G "core" switches). Stacking and distributed link aggregation allow for multi-resiliency with zero downtime and load balancing capabilities. Link Dependency new feature enables or disables ports based on the link state of different ports. Per VLAN Spanning Tree and Per VLAN Rapid Spanning Tree (PVSTP/ PVRSTP) offer interoperability with PVST+ infrastructures.

DHCP/BootP innovative auto-installation including firmware and configuration file upload automation. Industry standard SNMP, RMON, MIB, LLDP, AAA, sFlow and RSPAN remote mirroring implementation. Service port for out-of-band Ethernet management (OOB).

Standard RS232 straight-through serial RJ45 and Mini-USB ports for local management console. Standard USB port for local storage, logs, configuration or image files.

Dual firmware image for updates with minimum service interruption. Industry standard command line interface (CLI) for IT admins used to other vendors commands. Fully functional Web console (GUI) for IT admins who prefer an easy to use graphical interface.

Single-pane-of-glass NMS300 management platform with massconfiguration support. This item is in the category "Computers/Tablets & Networking\Enterprise Networking, Servers\Switches & Hubs\Network Switches". The seller is "box_uk" and is located in this country: GB. This item can be shipped to United Kingdom.

  • Brand: NETGEAR
  • Type: Ethernet Switch
  • Model: XSM4396K0-10000S
  • Network Management Type: Fully Managed
  • MPN: XSM4396K0-10000S
  • Unit Type: Unit
  • Country/Region of Manufacture: China
  • Custom Bundle: No
  • UPC: 606449130287
  • EAN: 1060644913028


Netgear M4300-96X 12-Slot Modular Stackable Managed Switch Empty Version   Netgear M4300-96X 12-Slot Modular Stackable Managed Switch Empty Version